ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE BATTERY


    1. A01382G

      Disconnect the negative battery cable.

    2. Disconnect the positive battery cable.

    3. Remove the bolt, clamp and battery.

  2. DRAIN ENGINE COOLANT

    Note

    To avoid the danger of being burned, do not remove the reservoir tank cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.


    1. A01375N

      Remove the drain plug and clip, then drain the engine coolant.

    2. Disconnect the radiator by uncoupling the radiator hose No.2.

    3. A01379O

      Remove the hose clamp, disconnect the water by-pass hose.

    4. Remove the reservoir tank cap sub-assembly.

      A01389E

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A0138NW

      Disconnect the engine coolant temperature sensor connector.

    2. A0138IUE01

      Remove the clip and engine coolant temperature sensor.

    3. Remove the O-ring from the water inlet.