MANIFOLD ABSOLUTE PRESSURE SENSOR (w/ Electronic Throttle Control System) REMOVAL


  1. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE FRONT AIR SHUTTER SEAL RH

    A013795

    1. Remove the 2 clips and front air shutter seal RH.

  3. REMOVE FRONT NO. 1 VENTILATOR SEAL

    A0137ZX

    1. Remove the 2 clips and No. 1 front ventilator seal.

  4. REMOVE COWL TOP PANEL OUTER

    A01392T

    1. Disengage the wire harness clamp.

    2. Disengage the grommet and separate the wire harness.

    3. A0137JB

      Remove the 10 bolts and cowl top panel outer.

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A0138QS

      Remove the 4 clamps.

    2. Remove the 2 clamps, then remove the air cleaner cap and air cleaner filter element.

  6. REMOVE THROTTLE BODY ASSEMBLY


    1. A0138QFE01

      Separate the clamps, disconnect the throttle motor connector.

    2. Loosen the 2 clips and disconnect the 2 water by-pass hoses.

    3. A01385I

      Remove the 4 bolts and throttle body.

  7. REMOVE THROTTLE BODY GASKET


    1. A0137VHE01

      Remove the gasket from the intake manifold.

  8. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    1. A01383R

      Disconnect the manifold absolute pressure sensor connector.

    2. Remove the 2 screws and manifold absolute pressure sensor.