KNOCK SENSOR INSTALLATION


  1. INSTALL KNOCK CONTROL SENSOR


    1. A0136V2E01

      Install the knock control sensor with the bolt.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Tech Tips

      It is acceptable for the sensor to be tilted 0° to 45°.

    2. Connect the knock control sensor connector.

  2. INSTALL OIL LEVEL GAUGE GUIDE


    1. A0137K7E01

      Apply a light coat of fresh engine oil to a new O-ring.

    2. A0138GBE02

      Install the oil level gauge guide with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Fit the 2 wire harness clamps into the oil level gauge guide.

  3. INSTALL COWL TOP PANEL OUTER

    A01377P

    1. Install the cowl top panel with the 10 bolts.

      Torque:
      9.2 N*m  { 94 kgf*cm, 81 in.*lbf }
    2. A01390L

      Install the grommet of the wire harness.

    3. Install the clamp of the wire harness.

  4. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY


    1. Connect the connector.

    2. A0136OQ

      Install the front wiper motor and link assembly with the 2 bolts.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

  5. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. Connect the washer hose.

    2. A0136GYE01

      Engage the 8 claws and install the cowl top ventilator louver RH.

    3. Install the clip.

  6. INSTALL COWL TOP VENTILATOR LOUVER LH


    1. Connect the washer hose.

    2. A0136Y2E01

      Engage the 9 claws and install the cowl top ventilator louver LH.

    3. Install the clip.

  7. INSTALL HOOD TO COWL TOP SEAL

    A01379NE01

    1. Engage the 8 clips and install the hood to cowl top seal.

  8. INSTALL FR WIPER ARM LH

    A01390ME03

    1. Scrape any metal powder off the serrated part of the wiper arm with a round file or equivalent (when reinstalling).

    2. Clean the wiper pivot serrations with a wire brush.

    3. Operate the wiper, then stop the windshield wiper motor assembly in the automatic stop position.

    4. Provisionally install the front wiper main arm with the nut.

    5. Install the front wiper secondary arm onto the front wiper motor and link assembly.

    6. A0138WNE04

      Align the blade tip with the mark on the windshield glass, as shown in the illustration.

    7. Tighten the nut of the front wiper main arm.

      Torque:
      21 N*m  { 209 kgf*cm, 15 ft.*lbf }

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  10. INSTALL FRONT WIPER ARM HEAD CAP

    A0137M4

    1. Engage the claw and install the front wiper arm head cap.