KNOCK SENSOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT WIPER ARM HEAD CAP

    A0136ST

    1. Using a screwdriver with its tip wrapped in protective tape, remove the front wiper arm head cap.

  3. REMOVE FR WIPER ARM LH


    1. Operate the wiper, then stop the windshield wiper motor assembly in the automatic stop position.

    2. A013933

      Remove the nut and front wiper main arm.

    3. A0135UZ

      Disengage the meshing of the secondary arm from the front wiper motor and link assembly.

      Note

      Do not bend the secondary arm when removing it.

  4. REMOVE HOOD TO COWL TOP SEAL

    A01379NE01

    1. Disengage the 8 clips and remove the hood to cowl top seal.

  5. REMOVE COWL TOP VENTILATOR LOUVER LH

    A0136Y2E01

    1. Remove the clip.

    2. Disengage the 9 claws and remove the cowl top ventilator louver LH.

    3. Disconnect the washer hose.

  6. REMOVE COWL TOP VENTILATOR LOUVER RH

    A0136GYE01

    1. Remove the clip.

    2. Disengage the 8 claws and remove the cowl top ventilator louver RH.

    3. Disconnect the washer hose.

  7. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

    A0136OQ

    1. Remove the 2 bolts.

    2. Disconnect the connector and remove the front wiper motor and link assembly.

  8. REMOVE COWL TOP PANEL OUTER

    A01390L

    1. Remove the clamp of the wire harness.

    2. Remove the grommet of the wire harness.

    3. A01377P

      Remove the 10 bolts and cowl top panel.

  9. REMOVE OIL LEVEL GAUGE GUIDE


    1. A0138GBE01

      Remove the 2 wire harness clamps from the oil level gauge guide.

    2. Remove the bolt and oil level gauge guide.

  10. REMOVE KNOCK CONTROL SENSOR


    1. Disconnect the knock control sensor connector.

    2. A013640E01

      Remove the bolt and knock control sensor.