Click here

КОЖУХ ВАЛА РЫЧАГА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ ПОВТОРНАЯ СБОРКА

Click here
Click here Click here
  1. Click here

    INSTALL SHIFT LEVER SHAFT OIL SEAL


    1. A01BBI6E01

      Using SST and a hammer, install a new oil seal until its surface is flush with the housing end surface.

      09550-10012 09252-10010

    2. Apply MP grease to the oil seal lip.

  2. Click here

    INSTALL SHIFT LEVER NO.2 SHAFT OIL SEAL


    1. A01BAOOE01

      Using SST and a hammer, install a new oil seal until its surface is flush with the housing end surface.

      09550-10012 09252-10010

    2. Apply MP grease to the oil seal lip.

  3. Click here

    INSTALL REVERSE RESTRICT PIN NO.1


    1. A01BDM4

      Coat the reverse restrict pin No.1 with gear oil.

    2. Install the spring to the reverse restrict pin No.1.

    3. Install the reverse restrict pin No.1 and spring to the shift lever shaft housing.

  4. Click here

    INSTALL REVERSE RESTRICT PIN SLOTTED SPRING PIN


    1. A01BGUF

      Using a pin punch (5 mm) and a hammer, install the slotted spring pin to the shift lever shaft housing.

  5. Click here

    INSTALL SELECT SPRING SEAT NO.1


    1. A01BASR

      Coat the select spring seat No.1 with gear oil.

    2. Install the select spring seat No.1 and spring to the shift lever shaft housing.

  6. Click here

    INSTALL SHIFT AND SELECT LEVER SHAFT


    1. A01BGUM

      Coat the shift and select lever shaft with gear oil.

    2. Install the shift and select lever shaft to the shift lever shaft housing.

  7. Click here

    INSTALL SHIFT LEVER SHAFT SET SLOTTED SPRING PIN


    1. A01BF60

      Using a pin punch (5 mm) and a hammer, install the shift lever shaft set slotted pin to the shift and select lever shaft.

  8. Click here

    INSTALL SHIFT LEVER BOOT


    1. A01BH8Q

      Install the shift lever boot to the shift lever shaft housing.

  9. Click here

    INSTALL SHIFT OUTER LEVER NO.1


    1. A01BDWB

      Install the shift outer lever No.1 to the shift and select lever shaft.

  10. Click here

    INSTALL SHIFT OUTER LEVER LOCK PIN


    1. A01BHBZ

      Install the shift outer lever lock pin to the shift outer lever No.1 with the nut.

      12 N*m 120 kgf*cm 9 ft.*lbf
  11. Click here

    INSTALL SELECT LEVER SHAFT SUB-ASSEMBLY


    1. A01BEBC

      Coat the select lever shaft with gear oil, and install it to the shift lever shaft housing.

  12. Click here

    INSTALL SELECT OUTER LEVER


    1. A01BD3T

      Install the select outer lever and washer to the select lever shaft.

  13. Click here

    INSTALL LEVER LOCK PIN NO.2


    1. A01BEXG

      Install the shift lever lock pin No.2 to the select outer lever with the nut.

      8.0 N*m 80 kgf*cm 71 in.*lbf