ГИДРОАККУМУЛЯТОР ПРИВОДА СЦЕПЛЕНИЯ (для моделей с 5L-E, 2KD-FTV) УСТАНОВКА


  1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY


    1. A01BC7M

      Install the clutch accumulator assembly with the 2 nuts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

    2. Using a union nut wrench, connect the 2 clutch tubes.

      Torque:
      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench Click here.

  2. ADD BRAKE FLUID

    A01BB0E
    Жидкость
    SAE J1703 или FMVSS № 116 DOT3 или аналогичное

  3. BLEED CLUTCH LINE


    1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  4. CHECK FOR BRAKE FLUID LEAKAGE

    Tech Tips

    Check for leakage in the clutch system.

  5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR


    1. Проверьте уровень жидкости и, при необходимости, долейте ее.

      Жидкость
      SAE J1703 или FMVSS № 116 DOT3 или аналогичная