Click here

СИСТЕМА БЛОКИРОВКИ СЕЛЕКТОРА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

Click here
Click here
  1. Click here

    INSPECT SHIFT LOCK CONTROL ECU

    Tip:

    Do not disconnect the shift lock control unit assembly connector.


    1. A01BH1SE01

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      5 (KLS+) - 1 (E) Ignition switch ACC and shift lever in P Below 1 V
      Ignition switch ACC and shift lever not in P 11 to 14 V
      6 (ACC) - 1 (E) Ignition switch ACC 11 to 14 V
      Ignition switch off Below 1 V
      4 (STP) - 1 (E) Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V
      8 (IG) - 1 (E) Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V
      10 (SLS-) - 1 (E) Ignition switch ON, brake pedal depressed and shift lever in P Below 2.5 V
      Ignition switch ON, brake pedal released and shift lever in P 11 to 14 V
      Table 1. Text in Illustration
      *a

      Component with harness connected

      (Shift Lock Control ECU)

      If the result is not as specified, replace the shift lock control ECU.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (E) - Body ground Always Below 1 Ω

      If the result is not as specified, replace the shift lock control ECU.