Click here

ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ СНЯТИЕ

Click here
Click here
  1. Click here

    DISCONNECT BATTERY NEGATIVE CABLE

  2. Click here

    DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01BGU8E05

      Remove the nut and disconnect the control cable assembly to the control shaft lever.

    2. Remove the clip and disconnect the control cable assembly.

  3. Click here

    REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01BBR8E01

      Remove the 2 bolts and heat insulator assembly from the park/neutral position switch assembly.

    2. A01BBCSE01

      Disconnect the connector from the park/neutral position switch assembly.

    3. A01BHXJE01

      Using a screwdriver, pry out the tabs of nut stopper and remove the lock nut and nut stopper.

    4. A01BEY3

      Remove the bolt and park/neutral position start switch assembly.

      Tip:

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.