Click here

СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ С ЭЛЕКТРОННЫМ УПРАВЛЕНИЕМ, Diagnostic DTC:P0756

Click here
Click here
DTC Code DTC Name
P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2)
Click here

ОПИСАНИЕ СИСТЕМЫ

The ECM uses signals from the vehicle speed sensor and direct clutch speed sensor to detect the actual gear position (1st, 2nd, 3rd or 4th gear).

Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transmission (clutch, brake or gear etc.).

DTC No. DTC Detection Condition Trouble Area
P0756 The gear required by the ECM does not match the actual gear when driving (1-trip detection logic)

  • Shift solenoid valve S2 remains open or closed

  • Valve body is blocked

  • Automatic transmission (clutch, brake or gear, etc.)
Click here

MONITOR DESCRIPTION

This DTC indicates "stuck ON malfunction" or "stuck OFF malfunction" of the shift solenoid valve S2.

The ECM commands gear shifts by turning the shift solenoid valves "ON/OFF". When the gear position commanded by the ECM and the actual gear position are not the same, the ECM illuminates the MIL and stores the DTC.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0756)


    1. Connect the Intelligent Tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn on the tester.

    4. Select the item "Power train / Engine and ECT / DTC / Current or Pending".

    5. Read the DTCs using the Intelligent Tester.

      Result
      Display (DTC output) Proceed to
      Only "P0756" is output A
      "P0756" and other DTCs B
      Tip:

      If any other codes besides "P0756" are output, perform troubleshooting for those DTCs first.


  2. Click here

    INSPECT SHIFT SOLENOID VALVE S2


    1. A01BEVTE01

      Remove the shift solenoid valve S2.

    2. Measure the resistance according to the value(s) in the table below.

      Resistance
      Tester Connection

      Specified Condition

      20°C (68°F)
      Solenoid Connector (S2) - Solenoid Body (S2) 11 to 15 Ω

    3. Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

      OK
      The solenoid makes an operating sound.

  3. Click here

    INSPECT TRANSMISSION VALVE BODY ASSEMBLY

    OK
    There are no foreign objects on each valve.

    • OK :REPAIR OR REPLACE AUTOMATIC TRANSMISSION ASSEMBLYClick here
    • NG :REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLYClick here
  4. Click here

    REPAIR OR REPLACE AUTOMATIC TRANSMISSION ASSEMBLY

  5. Click here

    GO TO DTC CHART

  6. Click here

    REPLACE SHIFT SOLENOID VALVE S2

  7. Click here

    REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLY