ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ УСТАНОВКА


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Install the park/neutral position switch to the automatic transmission.

    2. A01BAP6

      Temporarily install the bolt.

    3. A01BFAU

      Install a new lock washer and the nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    4. A01BBPPE01

      Turn the control shaft lever clockwise until it stops, and turn it counterclockwise 2 notches to set it to the N position.

    5. A01BCKQE06

      Align the neutral basic line with the switch groove, and tighten the adjusting bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }
    6. A01BHWF

      Using a screwdriver, bend the tabs of the lock washer.

    7. A01BHSTE01

      Connect the park/neutral position switch connector.

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01BDE0E01

      Connect the control cable with a new clip to the bracket.

    2. Temporarily install the control cable to the control shaft lever with the nut.

      Torque:
      15 N*m  { 150 kgf*cm, 10 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Apply the parking break and turn ignition switch on.

    2. Depress the break pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.

    3. Check that the back up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function.

    4. If a failure is found, check the park/neutral position switch for continuity.

  5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01BCKQE05

      Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

    2. Align the groove and the neutral basic line.

    3. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    4. After adjustment, perform the switch operation check.

  6. INSPECT SHIFT LEVER POSITION


    1. Переключая передачу только из положения P при включенном зажигании, нажмите педаль тормоза.

    2. Убедитесь, что рычаг переключения передач движется плавно и перемещается под умеренным усилием.

    3. Запустив двигатель, убедитесь, что при переключении рычага из положения N в положение D автомобиль двигается вперед, а при переключении в положение R - назад.

  7. ADJUST SHIFT LEVER POSITION


    1. A01BCKQE05

      Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.

    2. Align the groove and the neutral basic line.

    3. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    4. After adjustment, perform the switch operation check.

  8. PERFORM INITIALIZATION

    Click here