ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)


    1. Отсоедините разъем датчика температуры отработавших газов и открепите зажим.

    2. Отсоедините разъем датчика температуры отработавших газов № 2 и открепите 2 зажима.

    3. Отсоедините разъем датчика температуры отработавших газов № 3 и открепите 2 зажима.

    4. A01BCWL

      Отсоедините воздушный шланг выпускной трубы № 1 и воздушный шланг выпускной трубы № 7 от приемной трубы.

    5. A01BECT

      Снимите опоры выпускной трубы № 2 и № 4.

    6. Отверните 3 гайки и снимите приемную трубу.

    7. Снимите прокладку.

  3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Set the shift lever to the neutral position.

    2. A01BDE0E01

      Remove the nut from the control shaft lever.

    3. Remove the clip and disconnect the control cable from the control cable bracket.

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01BHSTE01

      Disconnect the park/neutral position switch connector.

    2. A01BFAPE03

      Using a screwdriver, pry out the lock washer.

    3. Remove the lock nut and lock washer.

    4. A01BAP6

      Remove the bolt and park/neutral position switch.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.