КОРПУС КЛАПАНОВ В СБОРЕ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY


    1. A01BH56

      Remove the ATF level gauge sub-assembly.

  3. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. A01BDMPE01

      Remove the drain plug, the gasket , and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 205 kgf*cm, 15 ft.*lbf }

  4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    1. A01BBQWE01

      Remove the 2 bolts and transmission oil filler tube sub-assembly.

    2. Remove the O-ring from the oil filler tube sub-assembly.

  5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01BHOD

      Remove the 19 bolts and oil pan sub-assembly.

    2. A01BCOUE01

      Install the blade of SST between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

      SST
      09032-00100

      Note

      When removing the oil pan, be careful not to damage the oil pan flange.

    3. A01BBFUE02

      Remove the 3 magnets from the oil pan.

    4. A01BAXO

      Examine particles in pan.


      1. Remove the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission. Steel (magnetic) ... bearing, gear and clutch plate wear Brass (non-magnetic) ... bushing wear

  6. TEMPORARILY TIGHTEN VALVE BODY OIL STRAINER ASSEMBLY


    1. A01BATPE01

      Remove the 4 bolts and oil strainer.

    2. Remove the 3 gaskets from the oil strainer.

  7. SEPARATE TRANSMISSION WIRE


    1. A01BESI

      Separate the ATF temperature sensor connector and shift solenoid valve connectors.

  8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. A01BDN0

      Remove the 20 bolts and valve body assembly.

  9. REMOVE SHIFT SOLENOID VALVE


    1. A01BHMWE01

      Remove the bolt and shift solenoid valve S1 and S2.

    2. Remove the bolt and shift solenoid valve SL.

    3. Remove the bolt, solenoid lock plate and shift solenoid valve SLT.

    4. Remove the O-rings from the shift solenoid valves (S1, S2, SL).