СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ С ЭЛЕКТРОННЫМ УПРАВЛЕНИЕМ ПРОЦЕДУРА ПОИСКА НЕИСПРАВНОСТЕЙ

When using intelligent tester, troubleshoot in accordance with the procedure on the following pages.
Tech Tips
- The TCM of this system is connected to the CAN system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN system.
- The intelligent tester can be used at steps 3, 4, 6, and 9.
1. Vehicle Brought to Workshop
  
  NEXT
2. Customer Problem Analysis
  
  NEXT
3. Connect the intelligent tester to DLC3
  
  NEXT
4. Check and Clear DTC and Freeze Frame Data
  
  NEXT
5. Visual Inspection
  
  NEXT
6. Setting the Check Mode Diagnosis
  
  NEXT
7. Problem Symptom Confirmation
  
  Symptom does not occur: Go to step 8
  
  Symptom occurs: Go to step 9
8. Symptom Simulation
  
  NEXT
9. DTC Check
  
  DTC is not output: Go to step 10
  
  DTC is output: Go to step 18
10. Basic Inspection
  
  NG
  Go to step 20
  
  OK
11. Mechanical System Test
  
  NG
  Go to step 17
  
  OK
12. Hydraulic Test
  
  NG
  Go to step 17
  
  OK
13. Manual Shifting Test
  
  NG
  Go to step 15
  
  OK
14. Problem Symptoms Table Chapter 1
  
  NG
  Go to step 19
  
  OK
15. Problem Symptoms Table Chapter 2
  
  NG
  Go to step 17
  
  OK
16. Problem Symptoms Table Chapter 3
  
  NEXT
17. Part Inspection
  
  Go to step 20
18. DTC Chart
  
  NEXT
19. Circuit Inspection
  
  NEXT
20. Repair or Replace
  
  NEXT
21. Confirmation Test
  
  NEXT
  
  End
When not using intelligent tester, troubleshoot in accordance with the procedure on the following pages.

Tech Tips

The TCM of this system is connected to the CAN system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN system.
1. Vehicle Brought to Workshop
  
  NEXT
2. Customer Problem Analysis
  
  NEXT
3. Check and Clear DTCs
  
  NEXT
4. Problem Symptom Confirmation
  
  Symptom does not occur: Go to step 5
  
  Symptom occurs: Go to step 6
5. Symptom Simulation
  
  NEXT
6. DTC Check
  
  DTC is not output: Go to step 7
  
  DTC is output: Go to step 15
7. Basic Inspection
  
  NG
  Go to step 17
  
  OK
8. Mechanical System Test
  
  NG
  Go to step 14
  
  OK
9. Hydraulic Test
  
  NG
  Go to step 14
  
  OK
10. Manual Shifting
  
  NG
  Go to step 12
  
  OK
11. Problem Symptoms Table Chapter 1
  
  NG
  Go to step 16
  
  OK
12. Problem Symptoms Table Chapter 2
  
  NG
  Go to step 14
  
  OK
13. Problem Symptoms Table Chapter 3
  
  NEXT
14. Part Inspection
  
  Go to step 17
15. DTC Chart
  
  NEXT
16. Circuit Inspection
  
  NEXT
17. Repair or Replace
  
  NEXT
18. Confirmation Test
  
  NEXT
  
  End