Click here

ГЕНЕРАТОР РАЗБОРКА

Click here
Click here Click here
  1. Click here

    REMOVE GENERATOR PULLEY CAP


    1. A01BBUT

      Using a screwdriver, remove the generator pulley cap.

  2. Click here

    REMOVE GENERATOR WITH CLUTCH PULLEY


    1. Mount the generator assembly in a vise between aluminum plates.

    2. A01BATDE01

      Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.

      09820-63021
      Table 1. Text in Illustration
      *1 Generator Rotor Shaft
      Note:

      Securely attach SST to the generator with clutch pulley and generator rotor shaft.

    3. A01BHZJE01

      Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.

      Table 2. Text in Illustration
      *a Hold
      A01BAZL Turn
      Note:

      Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

    4. Remove SST from the generator assembly.

    5. Remove the generator with clutch pulley from the rotor shaft.

  3. Click here

    REMOVE GENERATOR REAR END COVER


    1. A01BB8R

      Remove the 3 nuts and generator rear end cover.

  4. Click here

    REMOVE TERMINAL INSULATOR


    1. A01BDKR

      Remove the terminal insulator.

  5. Click here

    REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    1. A01BCZK

      Remove the 2 screws and generator brush holder assembly.

  6. Click here

    REMOVE GENERATOR COIL ASSEMBLY


    1. A01BB10

      Remove the 4 through bolts.

    2. A01BF20E02

      Using SST, remove the generator coil assembly.

      09950-40011 09951-04020 09952-04010 09953-04020 09954-04010 09955-04071 09957-04010 09958-04011
      Table 3. Text in Illustration
      *a Hold
      A01BAZL Turn
  7. Click here

    REMOVE GENERATOR ROTOR ASSEMBLY


    1. A01BBCF

      Remove the generator washer.

    2. A01BFB6

      Remove the generator rotor assembly from the generator drive end frame assembly.

  8. Click here

    INSPECT GENERATOR DRIVE END FRAME BEARING


    1. A01BF9F

      Check that the generator drive end frame bearing is not rough or worn.

      If necessary, replace the generator drive end frame bearing.

  9. Click here

    REMOVE GENERATOR DRIVE END FRAME BEARING


    1. A01BHFC

      Remove the 4 screws and retainer plate.

    2. A01BF1DE01

      Using SST and a hammer, tap out the generator drive end frame bearing.

      09950-60010 09951-00250
      09950-70010 09951-07100