НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ


  1. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tech Tips

    Collect the engine coolant in a container and dispose of it according to the local regulations.


    1. Loosen the radiator drain cock plug and drain the engine coolant.

      A01BC6OE01
      Text in Illustration
      *1 Radiator Reservoir Cap Sub-assembly *2 Radiator Reservoir Assembly
      *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
      *5 2-Way - -

    2. Remove the radiator reservoir cap sub-assembly.

    3. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INTAKE AIR CONNECTOR


    1. A01BGFJ

      Slide the clamp and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.

    2. Disconnect the vacuum hose from the intake air connector.

    3. Loosen the 2 hose clamps.

    4. Remove the 2 bolts and intake air connector.

  5. REMOVE FAN AND GENERATOR V BELT

    Click here

  6. REMOVE FAN PULLEY


    1. Отверните 4 гайки и снимите шкив вентилятора и распорную втулку вентилятора.

  7. REMOVE GENERATOR ASSEMBLY


    1. A01BGCM

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Remove the bolt and disconnect the wire harness clamp.

    5. A01BC3M

      Remove the 3 bolts and generator assembly.

  8. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    1. A01BHOE

      Выверните 2 болта и снимите натяжитель поликлинового ремня в сборе.

  9. DISCONNECT VANE PUMP ASSEMBLY


    1. A01BEMHE01

      Отсоедините разъем контактного датчика давления масла.

    2. Выверните 2 болта и отсоедините лопастной насос в сборе от двигателя.

    3. Обеспечьте надежную опору лопастного насоса.

  10. REMOVE ENGINE WATER PUMP ASSEMBLY


    1. A01BH6YE01

      Remove the 10 bolts, engine water pump assembly and gasket.