СИСТЕМА ОХЛАЖДЕНИЯ ПРОВЕРКА


  1. INSPECT RADIATOR RESERVOIR CAP SUB-ASSEMBLY


    1. Measure the valve opening pressure.


      1. A01BEM3E01
        Text in Illustration
        *1 O-ring
        *2 Rubber Packing

        If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

        Note

        Do not use any tools.

      2. Check that the O-ring is not deformed, cracked or damaged.

      3. Check that the O-ring is not swollen.

      4. If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

      5. Check that the O-ring is not deformed, cracked or swollen.

      6. Apply engine coolant to the O-ring and rubber packing before using the radiator cap tester.

      7. A01BEC3E16
        Text in Illustration
        *1 Radiator Reservoir Cap Sub-assembly
        *a Radiator Cap Tester
        *b 30° or more

        When using the cap tester, tilt it 30° or more.

      8. Pump the cap tester several times, and check the maximum pressure*1.

        Pumping speed
        1 pump per second

        Tech Tips

        *1: Even if the cap cannot maintain the maximum pressure, it is not necessarily defective.

        Judgment Criterion
        Item Specified Condition
        Standard value (for brand-new cap)

        94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 17.7 psi)
        Minimum standard value (for used cap)

        79 kPa (0.8 kgf/cm2, 11.4 psi)

        If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.