ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  3. REMOVE FRONT DOOR SCUFF PLATE RH

  4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.

  5. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A01BAN3E01

      Выверните болт и снимите трубку щупа проверки уровня моторного масла и кольцевое уплотнение.

  6. REMOVE FAN AND GENERATOR V BELT


    1. A01BHZDE01

      Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.

      Note

      When removing the fan and generator V belt, do not use the bolt of the idle pulley.

      Tech Tips

      After removing the fan and generator V belt, move the tensioner upward to the maximum amount.

  7. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    1. Отсоедините компрессор и разъем электромагнитной муфты.

    2. A01BB98E02

      Выверните 4 болта и отсоедините компрессор и электромагнитную муфту от двигателя.

      Tech Tips

      Отсоедините компрессор и электромагнитную муфту с трубопроводом низкого давления кондиционера № 1 и трубопроводом кондиционера высокого давления № 1, подвесив его на веревке.

    3. Обеспечьте надежную опору компрессора и электромагнитной муфты.

  8. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET


    1. A01BC29

      Выверните 5 болтов и снимите кронштейн крепления компрессора № 1.

  9. REMOVE CRANKSHAFT POSITION SENSOR


    1. A01BDLN

      Disconnect the crankshaft position sensor connector and detach the 2 wire harness clamps.

    2. A01BEWD

      Remove the bolt and crankshaft position sensor.