ECM УСТАНОВКА


  1. INSTALL ECM


    1. A01BBI1E02

      Install the ECM cover with the 4 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    2. Insert it in securely until it locks 4 ECM connectors.

    3. A01BH8XE01

      Temporarily install the ECM w/ cover to the clamp.

    4. Install the ECM w/ cover with the 2 clips.

      Note

      Do not use an ECM that was dropped or received strong impact.

    5. Install the floor carpet.

  2. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  3. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  4. INSTALL FRONT DOOR SCUFF PLATE RH

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION

    Click here

  7. INSTALL BATTERY SERVICE HOLE COVER (w/ Sub-battery)

  8. REGISTER ID CODE

    Click here

  9. CHECK ID CODE

    Click here

  10. INITIALIZE THE LEARNING VALUE OF THE SUPPLY PUMP ASSEMBLY


    1. Perform initialization procedures Click here.

      Note

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.