REAR STABILIZER BAR (for 4WD) INSPECTION


  1. INSPECT REAR STABILIZER LINK ASSEMBLY


    1. A017DOFE01

      Move the ball joint stud back and forth 5 times before installing the nut as shown in the illustration.

    2. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

      Turning torque
      1.0 N*m, (10 kgf*cm, 8.9 in.*lbf) or less

      If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

    3. Check for any cracks and grease leaks on the ball joint dust cover.