Click here

REAR AXLE HUB (for 2WD) ON-VEHICLE INSPECTION

Click here
Click here
Tip:

  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

Click here
  1. Click here

    REMOVE REAR WHEEL

  2. Click here

    SEPARATE REAR FLEXIBLE HOSE


    1. A017C06

      Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.

  3. Click here

    SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    1. A017FLR

      Remove the 2 bolts and separate the rear disc brake caliper assembly.

      Note:

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  4. Click here

    REMOVE REAR DISC


    1. A017FKWE01

      Put matchmarks on the rear disc and the axle hub.

    2. A017DGC

      Release the parking brake and remove the rear disc.

      Tip:

      If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.

  5. Click here

    INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A017EJZ

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum looseness
      0 mm (0 in.)
      Note:

      Ensure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

  6. Click here

    INSPECT REAR AXLE HUB RUNOUT


    1. A017FBT

      Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum runout
      0.08 mm (0.0031 in.)
      Note:

      Ensure that the dial indicator is set perpendicular to the measurement surface.

      If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

  7. Click here

    INSTALL REAR DISC


    1. A017FKWE01

      Align matchmarks and install the rear disc.

      Note:

      When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.

  8. Click here

    INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


    1. A017FLR

      Install the rear disc brake caliper assembly with the 2 bolts.

      78 N*m 795 kgf*cm 57 ft.*lbf
  9. Click here

    INSTALL REAR FLEXIBLE HOSE


    1. A017C06

      Install the rear flexible hose to the rear shock absorber with coil spring with the bolt.

      19 N*m 194 kgf*cm 14 ft.*lbf
      Note:

      Do not twist the rear flexible hose when installing it.

  10. Click here

    INSTALL REAR WHEEL

    103 N*m 1050 kgf*cm 76 ft.*lbf