Click here

REAR AXLE HUB (for 2WD) REMOVAL

Click here
Click here
Tip:

  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE REAR WHEEL

  3. Click here

    SEPARATE REAR FLEXIBLE HOSE


    1. A017C06

      Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.

  4. Click here

    SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    1. A017FLR

      Remove the 2 bolts and separate the rear disc brake caliper assembly.

      Note:

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  5. Click here

    REMOVE REAR DISC


    1. A017FKWE01

      Put matchmarks on the rear disc and the axle hub.

    2. A017DGC

      Release the parking brake and remove the rear disc.

      Tip:

      If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.

  6. Click here

    SEPARATE REAR SPEED SENSOR WIRE


    1. A017DR0

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note:

      Be careful not to damage the rear speed sensor.

  7. Click here

    REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. A017DQI

      Remove the 4 bolts and the rear axle hub and bearing assembly.

      Note:

      Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.

  8. Click here

    SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A017DVV

      Remove the bolt and the nut, and separate the No. 3 parking brake cable assembly.

  9. Click here

    REMOVE REAR STRUT ROD ASSEMBLY


    1. A017CFS

      Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.

      Note:

      Since stopper nuts are used, loosen the bolts.

  10. Click here

    REMOVE REAR AXLE CARRIER SUB-ASSEMBLY


    1. A017E2I

      Loosen the 2 bolts.

      Note:

      Since stopper nuts are used, loosen the bolts.

    2. A017DP6

      Remove the 2 bolts and 2 nuts, and separate the rear axle carrier sub-assembly from the rear shock absorber with coil spring.

    3. A017GBY

      Remove the 2 bolts, the 2 nuts, and the rear axle carrier sub-assembly.