TRANSFER OIL ON-VEHICLE INSPECTION


  1. INSPECT TRANSFER OIL


    1. A017BX2E03

      Remove the No. 1 transfer case plug and gasket.

    2. Check the oil level is within 0 to 5 mm (0 to 0.20 in.) below the lowest end of the hole for the No. 1 transfer case plug.

      Note


      • When changing oil, recheck the oil level after driving.

      • Excessively large or small quantity of oil may cause some trouble.

    3. When the oil level is too low, check for oil leakage.

    4. Tighten the No. 1 transfer case plug with a new gasket.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  2. ADD TRANSFER OIL


    1. Remove the No. 1 transfer case plug and gasket and supply oil.

      Note


      • When supplying oil, pour it slowly.

      • Supply oil several times at several minutes interval.

      Tech Tips

      The oil level should be within 0 to 5 mm (0 to 0.20 in.) below the lowest end of the hole for the No. 1 transfer case plug.

    2. After leaving it alone for 5 minutes, recheck the oil level.

    3. Tighten the No. 1 transfer case plug with a new gasket.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }