PARK / NEUTRAL POSITION SWITCH INSPECTION


  1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Jack up the vehicle.

    2. A017EN3E91

      Disconnect the park/neutral position switch connector.

    3. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

      Standard resistance
      Tester Connection Shift Position Specified Condition
      4 - 5 P and N Below 1 Ω
      Except P and N 10 kΩ or higher
      2 - 6 P Below 1 Ω
      Except P 10 kΩ or higher
      2 - 1 R Below 1 Ω
      Except R 10 kΩ or higher
      2 - 9 N Below 1 Ω
      Except N 10 kΩ or higher
      2 - 7 D, S, "+" and "-" Below 1 Ω
      Except D, S, "+" and "-" 10 kΩ or higher

      If the resistance value is not as specified, replace the park/neutral position switch.