PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE BATTERY


    1. A017ETJ

      Loosen the nut, and disconnect the negative battery terminal.

      CAUTION:

      Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    2. Remove the nut, and separate the positive battery terminal cable.

    3. Loosen the nut, and remove the bolt and battery clamp.

    4. Remove the battery and battery tray.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A017CN1

      Remove the 11 clips and cool air intake duct seal.

  4. REMOVE NO. 2 AIR CLEANER INLET


    1. A017D82

      Disconnect the 2 vacuum switching valve clamps.

    2. Disconnect the 2 vacuum hoses.

    3. Remove the 2 bolts and No. 2 air cleaner inlet.

  5. REMOVE NO. 1 AIR CLEANER INLET


    1. A017C2Q

      Disconnect the 2 vacuum hoses, and remove the 2 bolts and No. 1 air cleaner inlet.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A017BB9

      Disconnect the 3 vacuum hoses.

    2. A017EZ4

      Loosen the No. 1 air cleaner hose clamp.

    3. Disconnect the hose clamps and No. 2 ventilation hose.

    4. Disconnect the mass air flow meter connector.

    5. A017FXX

      Release the 2 clips, and remove the 2 bolts.

    6. Remove the air cleaner cap sub-assembly and air cleaner filter element.

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A017BI0

      Remove the 3 bolts, disconnect the hose and the connector, and remove the air cleaner case sub-assembly.

  9. REMOVE AIR CLEANER BRACKET


    1. A017BE8

      Remove the 2 bolts and air cleaner bracket.

  10. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A017FL3

      Remove the nut from the control shaft lever.

    2. Disconnect the control cable from the control shaft lever.

    3. A017DUX

      Remove the clip and disconnect the control cable from the control cable bracket.

      Note

      Do not hold the resin guide pipe.

  11. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A017BI1

      Disconnect the park/neutral position switch connector.

    2. A017FG9

      Remove the nut, washer and the control shaft lever.

    3. A017BBJ

      Using a screwdriver, pry up the lock plate.

    4. A017CJC

      Remove the lock nut and the lock plate.

    5. A017DOZ

      Remove the 2 bolts and pull out the park/neutral position switch.