FRONT CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE FRONT WHEEL RH

  2. REMOVE ENGINE UNDER COVER ASSEMBLY


    1. A017FPR

      Remove the 2 bolts and engine under cover assembly RR.

    2. A017FXN

      Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.

  3. REMOVE NO. 1 ENGINE UNDER COVER


    1. A017D1W

      Remove the 6 bolts, 2 clips and No. 1 engine under cover.

  4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH


    1. A017EVY

      Remove the clip.

    2. Using a 4 mm hexagon wrench, remove the screw.

    3. A017BNI

      Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly RH.

    4. Remove the pad from the front fender moulding sub-assembly RH.

    5. Remove the 2 clips No. 4 from the front fender moulding sub-assembly RH.

    6. A017BL5

      Remove the front fender side protector from the front fender moulding sub-assembly RH.

  5. REMOVE FRONT FENDER LINER RH


    1. A017B7YE01

      Remove the screw.

    2. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    3. A017CZV

      Using a 4 mm hexagon wrench, remove the 2 screws.

    4. Remove the 3 grommets.

      Tech Tips

      The grommets need to be replaced with new ones because they will break when they are removed.

    5. A017CFW

      Remove the 5 clips

    6. Remove the bolt, 8 screws and front fender liner RH.

  6. REMOVE FRONT FENDER APRON SEAL RH


    1. A017FOB

      Remove the 2 bolts, clip and front fender apron seal RH.

  7. REMOVE V-RIBBED BELT


    1. A017F8UE01

      Using SST, release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner assembly.

      SST
      09961-00950
    2. A017FUV

      While turning the V-ribbed belt tensioner assembly counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner assembly.

  8. REMOVE CRANKSHAFT PULLEY


    1. A017DGJE01

      Using SST, loosen the crankshaft pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. A017B61E01

      Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

  9. REMOVE TIMING CHAIN CASE OIL SEAL


    1. A017E9CE02

      Using a screwdriver, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.