Click here

DRIVE BELT REMOVAL

Click here
Click here
  1. Click here

    REMOVE FRONT WHEEL RH

  2. Click here

    REMOVE ENGINE UNDER COVER ASSEMBLY


    1. A017FPR

      Remove the 2 bolts and engine under cover assembly RR.

    2. A017FXN

      Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.

  3. Click here

    REMOVE NO. 1 ENGINE UNDER COVER


    1. A017D1W

      Remove the 6 bolts, 2 clips and No. 1 engine under cover.

  4. Click here

    REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH


    1. A017EVY

      Remove the clip.

    2. Using a 4 mm hexagon wrench, remove the screw.

    3. A017BNI

      Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly RH.

    4. Remove the pad from the front fender moulding sub-assembly RH.

    5. Remove the 2 clips No. 4 from the front fender moulding sub-assembly RH.

    6. A017BL5

      Remove the front fender side protector from the front fender moulding sub-assembly RH.

  5. Click here

    REMOVE FRONT FENDER LINER RH


    1. A017B7YE01

      Remove the screw.

    2. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    3. A017CZV

      Using a 4 mm hexagon wrench, remove the 2 screws.

    4. Remove the 3 grommets.

      Tip:

      The grommets need to be replaced with new ones because they will break when they are removed.

    5. A017CFW

      Remove the 5 clips

    6. Remove the bolt, 8 screws and front fender liner RH.

  6. Click here

    REMOVE FRONT FENDER APRON SEAL RH


    1. A017FOB

      Remove the 2 bolts, clip and front fender apron seal RH.

  7. Click here

    REMOVE V-RIBBED BELT


    1. A017F8UE01

      Using SST, release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner assembly.

      09961-00950
    2. A017FUV

      While turning the V-ribbed belt tensioner assembly counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner assembly.