HEATED OXYGEN SENSOR REMOVAL


  1. REMOVE ENGINE UNDER COVER ASSEMBLY


    1. A017FPR

      Remove the 2 bolts and engine under cover assembly RR.

    2. A017FXN

      Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.

  2. REMOVE NO. 1 ENGINE UNDER COVER


    1. A017B8T

      Remove the 6 bolts, 2 clips and No. 1 engine under cover.

  3. REMOVE NO. 2 ENGINE UNDER COVER


    1. A017CNJ

      Remove the 2 bolts and No. 2 engine under cover.

  4. REMOVE FRONT FLOOR COVER LH


    1. A017BWS

      Remove the 3 clamps, 6 bolts and front floor cover LH.

  5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)


    1. A017FGM

      Depress the brake pedal and hold it.

    2. Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.

      Tech Tips

      Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.

    3. A017FC7E01

      Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.

    4. Remove the 4 nuts, 4 bolts and 4 washers.

    5. A017G71

      Remove the 4 bolts and 4 adjusting shims.

    6. A017DKO

      Using a brass bar and a hammer, remove the propeller shaft with center bearing shaft assembly.

    7. A017G8QE01

      Insert SST into the transfer to prevent oil leakage.

      SST
      09325-20010

  6. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    1. A017DZ8

      Remove the 2 bolts and 2 compression springs.

    2. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

    3. Remove the gasket from the center exhaust pipe assembly.

  7. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    1. A017EM8

      Remove the 2 bolts and 2 compression springs.

    2. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

    3. Remove the gasket from the No. 3 exhaust pipe sub-assembly.

  8. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY


    1. A017C8S

      Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.

    2. A017F2Y

      Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.

    3. Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. A017CJP

      Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.

    2. A017EQE

      Loosen the bolt.

    3. Remove the 2 nuts and front exhaust pipe assembly.

    4. Remove the gasket from the front exhaust pipe assembly.

  10. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    1. A017BZAE01

      Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00010

  11. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    1. A017CD8E01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00010