Click here

ECM INSTALLATION

Click here
Click here
  1. Click here

    INSTALL NO. 2 ECM BRACKET


    1. A017DLVE01

      Install the 2 screws and No. 2 ECM bracket.

  2. Click here

    INSTALL NO. 1 ECM BRACKET


    1. A017DMSE01

      Install the 2 screws and No. 1 ECM bracket.

  3. Click here

    INSTALL ECM


    1. A017EOSE01

      Install the 2 nuts, bolt and ECM.

      8.0 N*m 82 kgf*cm 71 in.*lbf

    2. Install the wire harness clamp.

    3. Connect the 5 ECM connectors.

    4. Connect the harness connector (LHD).

  4. Click here

    INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    1. Connect each connector and clamp.

    2. A017F5K

      Engage the 4 claws and 3 clips.

    3. Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <F>.

  5. Click here

    INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A017F65

      Engage the 2 guides.

    2. Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.

  6. Click here

    INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

    Tip:

    Use the same procedure for the RH side and the LH side (Click here).

  7. Click here

    INSTALL FRONT DOOR SCUFF PLATE RH

    Tip:

    Use the same procedure for the RH side and the LH side (Click here).

  8. Click here

    REGISTER IMMOBILISER COMMUNICATION ID

    Note:

    If the ECM is replaced, register the ECM communication ID for the immobiliser system (Refer to the Service Bulletin for Registration).

  9. Click here

    PERFORM INITIALIZATION

    Note:

    If the ECM is replaced, perform RESET MEMORY (AT initialization) (Click here).