Click here

SFI SYSTEM, Diagnostic DTC:P0560

Click here
Click here
DTC Code DTC Name
P0560 System Voltage
Click here

DESCRIPTION

The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM will illuminate the MIL and set the DTC.

DTC No. DTC Detection Condition Trouble Area
P0560

Open in ECM back-up power source circuit

(1 trip detection logic)

  • Open in back-up power source circuit

  • EFI No. 1 fuse

  • ECM
Tip:

If DTC P0560 is set, the ECM does not store other DTCs.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Tip:

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

Click here

PROCEDURE


  1. Click here

    CHECK FUSE (EFI NO. 1 FUSE)


    1. A017ENJE04

      Remove the EFI No.1 fuse from the engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      EFI No. 1 Fuse Always Below 1 Ω

    3. Reinstall the EFI No. 1 fuse.


  2. Click here

    INSPECT ECM (BATT VOLTAGE)


    1. A017BQGE06

      Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      D31-3 (BATT) - B3-1 (E1) Always 9 to 14 V

  3. Click here

    CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE)


    1. A017F6ME02

      Remove the EFI No. 1 fuse from the relay block.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for open)
      Tester Connection Condition Specified Condition
      EFI No. 1 fuse (2) - D31-3 (BATT) Always Below 1 Ω
      Standard resistance (Check for short)
      Tester Connection Condition Specified Condition
      EFI No. 1 fuse (2) or D31-3 (BATT) - Body ground Always 10 kΩ or higher

    4. Reconnect the ECM connector.

    5. Reinstall the EFI No. 1 fuse.


  4. Click here

    CHECK FOR SHORT IN ALL HARNESS AND COMPONENTS CONNECTED TO FUSE, AND REPLACE FUSE (EFI NO. 1 FUSE)

  5. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  6. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  7. Click here

    CHECK AND REPLACE ENGINE ROOM RELAY BLOCK