Click here

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System), Diagnostic DTC:B1441/41

Click here
Click here
DTC Code DTC Name
B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side)
Click here

DESCRIPTION

The air mix control servo motor sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (front passenger side) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.

Tip:

Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.

DTC No. DTC Detection Condition Trouble Area
B1441/41 Air mix damper position does not change even if air conditioning amplifier operates air mix control servo motor

  • Air mix control servo motor

  • Air conditioning harness

  • Air conditioning amplifier
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    READ VALUE USING INTELLIGENT TESTER (AIR MIX PULSE-P)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.

    3. Select the item below in the Data List, and read the value displayed on the intelligent tester.

      Table 1. Data List / Air Conditioner:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Air Mix Pulse-P

      Passenger side air mix control servo motor target pulse /

      Min.: 0, Max.: 255

      • LHD

        MAX. COLD: 105 (pulse)

        MAX. HOT: 7 (pulse)


      • RHD

        MAX. COLD: 5(pulse)

        MAX. HOT: 103 (pulse)

      		 -
      OK
      The display is as specified in the normal condition column.
      Result
      Result Proceed to
      NG A
      OK (Checking from PROBLEM SYMPTOMS TABLE) B
      OK (Checking from DTC) C

  2. Click here

    REPLACE AIR MIX CONTROL SERVO MOTOR


    1. Replace the air mix control servo motor (Click here).


  3. Click here

    END (AIR MIX CONTROL SERVO MOTOR IS DEFECTIVE)

  4. Click here

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  5. Click here

    REPLACE AIR CONDITIONING AMPLIFIERClick here

  6. Click here

    REPAIR OR REPLACE AIR CONDITIONING HARNESS

  7. Click here

    CHECK DTC OUTPUT


    1. Clear the DTC (Click here).

    2. Check for DTC (Click here).

      OK
      DTC B1441/41 is not output.