Click here

STEERING LOCK SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here
Tip:

  • Perform troubleshooting in accordance with the following flowchart.


  • *: Use the intelligent tester.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    • NEXT
  3. Click here

    CHECK AND CLEAR DTCS*


    • NEXT
  4. Click here

    PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    • B
    • Go to step 6
    • A
  5. Click here

    SYMPTOM SIMULATION


    • NEXT
  6. Click here

    CHECK CAN COMMUNICATION SYSTEM*

    Tip:

    Check that there are no problems in the CAN communication system before troubleshooting the steering lock system.


    • NEXT
  7. Click here

    DTC CHECK*


    1. Check for DTC (Click here).

      Result
      Result Proceed to
      DTC is output. A
      DTC is not output. B

      • A
      • Go to step 9
      • B
  8. Click here

    PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    • B
    • Go to step 10
    • A
  9. Click here

    DTC CHART


    • NEXT
  10. Click here

    CIRCUIT INSPECTION*


    • NEXT
  11. Click here

    PROBLEM IDENTIFICATION


    • NEXT
  12. Click here

    REPAIR OR REPLACEMENT


    • NEXT
  13. Click here

    CONFIRMATION TEST*


    • NEXT
    • END