POWER STEERING SYSTEM PRECAUTION

Note

When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

System Name See procedure
Parking Assist Monitor System

Click here

Power Back Door System

  1. IGNITION SWITCH EXPRESSIONS

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Switch Type Ignition Switch (position) Engine Switch (condition)
    Expression Ignition switch off LOCK Off
    Ignition switch on (IG) ON On (IG)
    Ignition switch on (ACC) ACC On (ACC)
    Engine start START Start

  2. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM


    1. The vehicle is equipped with an SRS (Supplemental Restraint System) such as airbags. Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.

      Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System Click here.

  3. PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC POWER STEERING COMPONENTS


    1. Be sure to align the front wheels straight ahead when removing and installing the power steering gear assembly.

    2. If disconnecting the steering sliding yoke sub-assembly and the pinion shaft of the power steering gear assembly, be sure to place matchmarks before starting the operation.

  4. HANDLING PRECAUTION


    1. When handling the electronic parts:


      • Avoid any impact to electronic parts such as ECUs and relays. Replace them with new ones if dropped or subjected to a severe blow.

      • Do not expose any electronic parts to high temperatures and humidity.

      • In order to prevent deformation or malfunctions due to static electricity, do not touch the connector terminals.

    2. When handling the steering column:


      • Avoid any impact to the steering column, especially to the motor and torque sensor. Replace them with new ones if dropped or subjected to a severe blow.

      • Do not pull the wire harness when moving the steering column.

    3. When disconnecting and reconnecting the connectors:

      When disconnecting the connectors related to the power steering system, turn the ignition switch on (IG), center the steering wheel, turn the ignition switch off, and then disconnect the connectors.

  5. PRECAUTIONS FOR CAN COMMUNICATION


    1. CAN communication lines are used to receive information from the skid control ECU and the ECM, and to transmit warnings to the combination meter.

      When there are any problems in the CAN communication lines, CAN communication system DTCs are output.

    2. Perform troubleshooting for the communication line problems when the CAN communication DTCs are output. Be sure to start troubleshooting on the power steering system after confirming that the CAN communication system is normal.

    3. Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.