Click here

FRONT BRAKE FLEXIBLE HOSE INSTALLATION

Click here
Click here
Note:

  • Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Click here
  1. Click here

    INSTALL FRONT FLEXIBLE HOSE


    1. A017CT6

      Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.

      30 N*m 306 kgf*cm 22 ft.*lbf
    2. A017CI0

      Install the front flexible hose with a new clip.

      Note:

      Install the clip as far as it will go.

    3. A017G9ME01

      Using a union nut wrench (10 mm), connect the brake line to the front flexible hose while holding the front flexible hose with a wrench.

      without union nut wrench
      15 N*m 155 kgf*cm 11 ft.*lbf
      with union nut wrench
      14 N*m 143 kgf*cm 10 ft.*lbf
      Note:

      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt and dust to enter the brake line.

      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when the union nut wrench is parallel to the torque wrench.

    4. A017CY5

      Install the front flexible hose to the absorber bracket with the bolt.

      19 N*m 194 kgf*cm 14 ft.*lbf
  2. Click here

    BLEED BRAKE SYSTEM

    (Click here)

  3. Click here

    INSTALL FRONT WHEEL

    103 N*m 1050 kgf*cm 76 ft.*lbf