STOP LIGHT CONTROL RELAY ON-VEHICLE INSPECTION


  1. INSPECT STOP LIGHT CONTROL RELAY


    1. Remove the stop light control relay.

    2. A017B3RE07

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      3 - 4 Voltage is not applied between terminals 1 and 2 Below 1 Ω
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 4 Voltage is applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the value is not as specified, replace the stop light control relay.