REAR SPEED SENSOR (for 2WD) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.

  • If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly Click here.

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A017EJZ

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum looseness
      0 mm (0 in.)

      Note

      Ensure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

  3. INSPECT REAR AXLE HUB RUNOUT


    1. A017FBT

      Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum runout
      0.08 mm (0.0031 in.)

      Note

      Ensure that the dial indicator is set perpendicular to the measurement surface.

      If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

  4. INSTALL REAR DISC


    1. A017FKWE01

      Align matchmarks and install the rear disc.

      Note

      When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.

  5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


    1. A017FLR

      Install the rear disc brake caliper assembly with the 2 bolts.

      Torque:
      78 N*m  { 795 kgf*cm, 57 ft.*lbf }

  6. INSTALL REAR SPEED SENSOR WIRE


    1. A017FKF

      Connect the connector to the rear speed sensor.

  7. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  10. CHECK FOR REAR SPEED SENSOR SIGNAL

    Click here