FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.

    Click here

    Click here


  1. INSTALL FRONT SPEED SENSOR


    1. A017B3HE01

      Install the resin clamp and the front speed sensor with bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Firmly insert the front speed sensor body into the knuckle before tightening the bolt.

      • After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and knuckle. Also make sure that no foreign matter is stuck between the parts.

      • Before installing the clamp, firmly insert the points of the clamp into the installation holes.

    2. A017CRNE01

      Temporarily install the No. 1 sensor clamp.

      Note

      Be sure to insert the No. 1 sensor clamp claw into the stopper hole while installing the No. 1 sensor clamp.

    3. A017FKUE02

      Install the front flexible hose and the No. 1 sensor clamp together to the shock absorber with the bolt.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing it.

      • A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.

    4. A017B43E02

      Install the No. 2 sensor clamp to the body with the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    5. A017EQH

      Install the 2 clamps and connect the front speed sensor connector.

  2. INSTALL FRONT FENDER LINER

    Click here

  3. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK FOR SPEED SENSOR SIGNAL

    Click here