FRONT SPEED SENSOR REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The following procedures is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.

    Click here

    Click here


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT WHEEL

  3. REMOVE FRONT FENDER LINER

    Click here

  4. REMOVE FRONT SPEED SENSOR


    1. A017EQH

      Disconnect the front speed sensor connector and remove the 2 clamps.

    2. A017B43E01

      Remove the bolt and No. 2 sensor clamp from the body.

    3. A017FMLE01

      Remove the bolt, No. 1 sensor clamp, and flexible hose together from the shock absorber assembly.

    4. A017CELE02

      Remove the bolt, resin clamp, and the front speed sensor.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the installation hole and the connect surface for the front speed sensor every time it is removed.