Click here

STEERING ANGLE SENSOR REMOVAL

Click here
Click here
  1. Click here

    PRECAUTION

    (Click here)

  2. Click here

    FRONT WHEELS FACING STRAIGHT AHEAD

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)

  4. Click here

    REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A017F4M

      Disengage the claw and remove the lower No. 3 steering wheel cover.

  5. Click here

    REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A017BJG

      Disengage the claw and remove the lower No. 2 steering wheel cover.

  6. Click here

    REMOVE STEERING PAD


    1. A017BXEE01

      Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.

    2. A017C2G

      Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

      Note:

      When removing the steering pad, do not pull the airbag wire harness.

    3. A017ETNE01

      Disconnect the horn connector from the steering pad.

    4. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

  7. Click here

    REMOVE STEERING WHEEL ASSEMBLY


    1. A017E10E01

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and the steering main shaft.

    3. Disconnect the connectors from the spiral cable.

    4. A017FPJE01

      Using SST, remove the steering wheel assembly.

      09950-50013 09951-05010 09952-05010 09953-05020 09954-05021
      Note:

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  8. Click here

    REMOVE STEERING COLUMN COVER


    1. A017BZ5

      Remove the 2 screws.

    2. A017D1F

      Disengage the 2 claws to remove the lower steering column cover.

    3. A017BQ8

      Disengage the claw to remove the upper steering column cover.

  9. Click here

    REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR


    1. A017CN8

      Disconnect the connectors from the spiral cable with steering angle sensor.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Disengage the 3 claws and remove the spiral cable with steering angle sensor.

  10. Click here

    REMOVE STEERING ANGLE SENSOR


    1. A017D3OE02

      Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.