BACK DOOR ADJUSTMENT


  1. INSPECT BACK DOOR


    1. Check that the clearance of areas A to P are within the standard range.

      A01BDKNE01
      Standard
      Area Measurement Area Measurement
      A 21.4 mm (0.843 in.) I 21.5 mm (0.847in.)
      B 5.2 mm (0.205 in.) J 5.2mm (0.205in.)
      C 10.1 mm (0.398 in.) K 10.4 mm (0.409in.)
      D 110.9 mm (4.366 in.) L 111 mm (4.37in.)
      E 20 mm (0.787 in.) M 18 mm (0.709in.)
      F 5.2 mm (0.205 in.) N 5.2 mm (0.205in.)
      G 10.2 mm (0.402 in.) O 10.4 mm (0.409in.)
      H 110.9 mm (4.366in.) P 111 mm (4.37in.)

  2. ADJUST BACK DOOR


    1. Disconnect the cable from negative (-) battery terminal from the battery.

      CAUTION:

      Work must be started at least 90 seconds after the engine switch is turned off and the negative(-) terminal cable is disconnected from the battery. (The SRS is equipped with a back-up power source. If work is started within 90 seconds of disconnecting the cable from the negative (-) battery terminal and turning the engine switch off, the SRS may deploy.)

    2. A01BBPY

      Loosen the bolts to adjust the back door upper up and down, side to side.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

    3. When adjusting the back door rear side to side, and the back door lock striker assembly, loosen the bolts until the striker can move. Lightly tap the striker with a brass bar for adjustment.

      A01BF3ME01
      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

    4. After completing fitting adjustment, confirm the position of the back door side female stopper and back door side male stopper.

      A01BFE8E01
      Torque:
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }

    5. Connect the negative (-) terminal cable to the battery.

    6. Initialize both systems.

    7. Inspect the SRS warning light.