POWER SLIDE DOOR MOTOR ASSEMBLY INSTALLATION


  1. INSTALL POWER SLIDE DOOR MOTOR ASSEMBLY


    1. A01BGBP

      Install the power slide door motor with the 10 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }
    2. A01BE2S

      Install the 2 grommets.

    3. Install the slide door lower roller assembly LH onto the belt bracket of the power slide door motor assembly.

    4. A01BBPH

      Install the slide door lower rail plate with the bolt.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }
    5. A01BABJ

      Tighten the slide door lower roller assembly LH and belt bracket with the 2 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  2. INSTALL REAR NO. 2 DOOR WIRE


    1. A01BENY

      Make sure that the wire harness is not twisted, and tighten the bolts after the clamp is fully secured by turning it in the direction indicated by the arrow mark.

    2. Connect the connector.

  3. INSTALL DOOR CONTROL RELAY ASSEMBLY

    A01BAHA

    1. Install the door control relay with the bolt.

    2. Connect the connectors.

  4. INSTALL SIDE STEP REAR SUPPORT LH

    A01BCL4

    1. Install the side step rear support with the 3 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  5. INSTALL REAR DOOR SCUFF PLATE LH


    1. A01BDOD

      Connect the connector.

    2. Engage the claw and 12 clips and install the rear door scuff plate.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }