POWER SLIDE DOOR MAIN SWITCH INSPECTION


  1. INSPECT POWER SLIDE DOOR MAIN SWITCH


    1. A01BANDE01

      Check the resistance.


      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard resistance
        Tester Connection Condition Specified Condition
        3 - 4 Switch released 10 kΩ or higher
        3 - 4 Switch pressed in Below 1 Ω
        4 - 5 Switch released Below 1 Ω
        4 - 5 Switch pressed in 10 kΩ or higher

        If the result is not as specified, replace the power slide door main switch.

    2. Check the illumination operation.


      1. Apply battery voltage to the power slide door main switch and check that the illumination comes on.

        Standard
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 2

        Battery negative (-) → Terminal 1

        		 Illumination comes on

        If the result is not as specified, replace the power slide door main switch.