POWER SLIDE DOOR SYSTEM Slide Door Handle Switch LH Circuit

DESCRIPTION

When the power slide door ECU LH receives a switch signal from the slide door lock remote control LH (position switch), the power slide door ECU LH restricts operation of the power slide door.

WIRING DIAGRAM

A01BFN5E02

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH (HANDLE SWITCH)


    1. A01BH6ME01

      Disconnect the p7 connector from the slide door lock remote control assembly LH (handle switch).

    2. Measure the resistance of the handle switch.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      p7-1 - p7-2 Handle in initial position 10 kΩ or higher
      p7-1 - p7-2 Handle pulled Below 1 Ω

    NG

    REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH

    OK

  2. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH (POSITION SWITCH)


    1. A01BBFWE02

      Disconnect the p5 connector from the slide door lock remote control assembly LH (position switch in the actuator).

    2. Measure the resistance of the position switch.

      Standard resistance
      Tester Connection Door Lock Condition Specified Condition
      p5-1 - p5-4 Lock 10 kΩ or higher
      p5-1 - p5-4 Unlock Below 1 Ω

    NG

    REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH

    OK

  3. CHECK HARNESS AND CONNECTOR (HANDLE SWITCH CIRCUIT)


    1. A01BD5VE01

      Disconnect the q4 connector from the power slide door ECU LH.

    2. Measure the resistance.

      Standard resistance
      Tester Connection Condition Specified Condition
      q4-8 (MPX1) - p7-1 Always Below 1 Ω
      q4-13 (OSG) - p7-2 Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (POSITION SWITCH CIRCUIT)


    1. A01BCRTE02

      Disconnect the q4 connector from the power slide door ECU LH.

    2. Measure the resistance.

      Standard resistance
      Tester Connection Condition Specified Condition
      q4-22 (DLSW) - p5-4 Always Below 1 Ω
      q4-13 (OSG) - p5-1 Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE POWER SLIDE DOOR ECU LH