POWER SLIDE DOOR SYSTEM, Diagnostic DTC:2-2

DTC Code DTC Name
2-2 Door Lock Pawl Switch Malfunction

DESCRIPTION

Code 2-2 is output when the power slide door lock assembly LH (pawl switch) is malfunctioning.

DTC No. DTC Detection Condition Trouble Area
2-2

  • During self-diagnostic mode 1, pawl switch ON/OFF signals are not output correctly when power slide door is operated

  • Power slide door lock assembly LH

  • Power slide door ECU LH

  • Wire harness

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT POWER SLIDE DOOR LOCK ASSEMBLY LH (PAWL SWITCH)


    1. Disconnect the p1 connector from the power slide door lock assembly LH.

    2. A01BCUTE03

      Measure the resistance of the pawl switch.

      Standard resistance
      Tester Connection Door Lock Condition Specified Condition
      p1-9 (POL) - p1-8 (E1)

      Half-latch and full-latch ON range

      ↓

      Half-latch OFF range and full-latch ON range

      10 kΩ or higher

      ↓

      Below 1 Ω

      ↓

      10 kΩ or higher
      p1-9 (POL) - p1-8 (E1)

      Half-latch OFF range and full-latch ON range

      ↓

      Half-latch and full-latch OFF range

      10 kΩ or higher

      ↓

      Below 1 Ω

      ↓

      10 kΩ or higher

    NG

    REPLACE POWER SLIDE DOOR LOCK ASSEMBLY LH

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR LOCK ASSEMBLY LH - POWER SLIDE DOOR ECU LH)


    1. A01BG2FE03

      Disconnect the q4 connector from the power slide door ECU LH.

    2. Measure the resistance.

      Standard resistance
      Tester Connection Condition Specified Condition
      q4-18 (POL) - p1-9 (POL) Always Below 1 Ω
      q4-13 (SGND) - p1-8 (E1) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE POWER SLIDE DOOR ECU LH