POWER SLIDE DOOR SYSTEM, Diagnostic DTC:1-3

DTC Code DTC Name
1-3 Door Lock Full-latch Switch Malfunction

DESCRIPTION

Code 1-3 is output when the power slide door lock assembly LH (latch switch (full-latch)) is malfunctioning.

DTC No. DTC Detection Condition Trouble Area
1-3

  • During self-diagnostic mode 1, full-latch switch ON/OFF signals are not output correctly when power slide door is operated

  • Power slide door lock assembly LH

  • Power slide door ECU LH

  • Wire harness

WIRING DIAGRAM

A01BFG5E02

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT POWER SLIDE DOOR LOCK ASSEMBLY LH (LATCH SWITCH)


    1. A01BCUTE01

      Disconnect the p1 connector from the power slide door lock assembly LH.

    2. Measure the resistance of the latch switch (full-latch).

      Standard resistance
      Tester Connection Door Lock Condition Specified Condition
      p1-4 (FUL) - p1-8 (E1) Full-latch ON range Below 1 Ω
      p1-4 (FUL) - p1-8 (E1) Over-stroke 10 kΩ or higher

    NG

    REPLACE POWER SLIDE DOOR LOCK ASSEMBLY LH

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR LOCK ASSEMBLY LH - POWER SLIDE DOOR ECU LH)

    A01BG2FE05

    1. Disconnect the q4 connector from the power slide door ECU LH.

    2. Measure the resistance.

      Standard resistance
      Tester Connection Condition Specified Condition
      q4-5 (FUL) - p1-4 (FUL) Always Below 1 Ω
      q4-13 (OSG) - p1-8 (E1) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE POWER SLIDE DOOR ECU LH