SPIRAL CABLE REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE STEERING PAD

    Click here

  5. REMOVE STEERING WHEEL ASSEMBLY


    1. Remove the steering wheel set nut.

    2. A01BCKRE01
      Text in Illustration
      *a Matchmark
      *b Hold
      *c Turn

      Put matchmarks on the steering wheel assembly and steering main shaft assembly.

    3. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  6. REMOVE NO. 2 STEERING COLUMN LOWER COVER (w/ Smart Entry and Start System)


    1. A01BGLA

      Detach the 4 claws and remove the No. 2 steering column lower cover.

  7. REMOVE LOWER STEERING COLUMN COVER

    Tech Tips

    Adjust the position of the steering tilt mechanism when performing the procedure.


    1. A01BFYN

      Remove the 2 "TORX" screws (T25) from the steering column lower cover.

    2. A01BGF5

      Push the steering column lower cover inward on both sides to detach the 2 claws.

    3. A01BF7C

      Detach the 2 claws and remove the steering column lower cover.

  8. REMOVE COMBINATION METER ASSEMBLY

    Click here

  9. REMOVE UPPER STEERING COLUMN COVER


    1. A01BGF6E01
      Text in Illustration
      *a Front of Vehicle
      *b Raise the backside of the steering column upper cover
      *c Pull diagonally backwards so that the claw of the steering column upper cover does not break

      Remove the steering column upper cover from the steering column assembly.

      Note

      If the steering column upper cover is removed by pulling it directly upwards, the claw may become damaged.

  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable sub-assembly with the battery connected and the ignition switch ON.


    1. A01BATXE01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect the connector from the spiral cable sub-assembly.

    3. Detach the 3 claws and remove the spiral cable sub-assembly.

      A01BAHL