STEERING PAD REMOVAL


  1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

    Note

    Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

  2. REMOVE STEERING WHEEL COVER LOWER NO.2


    1. Using a screwdriver, remove the steering wheel No.2 cover lower.

      Tech Tips

      Tape up the screwdriver tip before use.

  3. REMOVE STEERING WHEEL COVER LOWER NO.3


    1. Using a screwdriver, remove the steering wheel No.3 cover lower.

      Tech Tips

      Tape up the screwdriver tip before use.

  4. REMOVE STEERING PAD


    1. A01BDT6E01

      Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.

    2. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

    3. Disconnect the horn connector.

    4. A01BHTI

      Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.