REAR BLOWER SWITCH (for Cooler) INSPECTION


  1. INSPECT COOLER CONTROL SWITCH


    1. Remove the cooler control switch and disconnect the connector.

    2. A01BACN

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester connection Switch position Specified condition
      Each terminal OFF 10 kΩ or higher
      4 - 8 LO Below 1 Ω
      1 - 4 - 8 LO - ME Below 1 Ω
      1 - 4 - 8 ME Below 1 Ω
      1 - 4 - 6 - 8 ME - HI Below 1 Ω
      4 - 6 - 8 HI Below 1 Ω

      If the resistance value is not as specified, replace the cooler control switch.