VANE PUMP (for TR Series Engine) INSTALLATION


  1. INSTALL VANE PUMP ASSEMBLY


    1. A01BHQH

      Install the vane pump assembly with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 16 ft.*lbf }
    2. A01BD9SE01

      Connect the oil pressure switch connector.

  2. CONNECT PRESSURE FEED TUBE ASSEMBLY


    1. Install a new gasket to the pressure feed tube assembly.

    2. A01BDIQE01

      Connect the pressure feed tube assembly (pressure feed tube side) to the vane pump assembly with the union bolt.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Tech Tips

      Make sure the stopper of the pressure feed tube assembly contacts the vane pump body as shown in the illustration.

    3. A01BH1BE01

      Connect the pressure feed tube assembly (return tube side) to the vane pump assembly with the clip.

  3. INSTALL FAN & GENERATOR V BELT

    A01BH2EE02

    1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

    2. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

      Note


      • The backside of the drive belt should face the tensioner pulley.

      • Check that the drive belt is properly set to each pulley.

    3. A01BENJE02

      After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

  4. ADD POWER STEERING FLUID

  5. BLEED POWER STEERING FLUID

    Click here

  6. CHECK FOR POWER STEERING FLUID LEAKS