2KD-FTV VACUUM PUMP INSTALLATION


  1. INSTALL VACUUM PUMP ASSEMBLY


    1. Apply the engine oil to the 2 new O-rings.

    2. Install the 2 O-rings to the vacuum pump assembly.

    3. A01BDDZ

      Install the vacuum pump assembly to the engine with the 2 nuts.

      Torque:
      21 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Note


      • Do not drop the vacuum pump packing.

      • Make sure that the vacuum pump assembly is securely installed.

    4. A01BDP4

      Install the vacuum pump union and the 2 new gaskets with the union bolt.

      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

      Note

      Check that the stopper of the vacuum pump union is securely holding on the vacuum pump assembly.

    5. Connect the 2 hoses with the clip to the vacuum pump.

      Note

      Set the vacuum hose so the white marking facing upward.

  2. INSPECT VACUUM PUMP ASSEMBLY


    1. Disconnect the vacuum hose.

    2. Connect the vacuum gauge to the vacuum pump.

    3. Start the engine.

    4. A01BBFNE02

      Measure the vacuum with the engine idling.

      Standard
      More than 650 mmHg (86.7 kPa).

  3. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.2

  4. INSTALL ENGINE UNDER COVER NO.1