REAR BRAKE FLEXIBLE HOSE INSTALLATION


  1. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE


    1. A01BHDC

      Using SST, install the rear brake tube flexible hose.

      SST
      09023-12701
      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

    2. Install the flexible hose with a new clip.

      Note


      • When installing the rear brake flexible hose, face the identification mark to the exterior of the vehicle and minimize twisting of the hose.

      • Install the clip as far as it will go.

    3. Connect the brake tube to rear brake flexible hose with SST while holding the rear brake flexible hose with a wrench.

      SST
      09023-00101
      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.

  2. ADD BRAKE FLUID

    A01BB0E
    Fluid
    SAE J1703 or FMVSS No. 116 DOT3 or equivalent

  3. BLEED BRAKE LINE


    1. Connect the vinyl tube to the bleeder plug.

    2. Depress the brake pedal several times and loosen the bleeder plug with the pedal held down.

    3. At the point where the fluid stops coming out, tighten the bleeder plug and release the brake pedal.

    4. Repeat this procedure until the air in the brake fluid is completely bled out.

    5. Tighten the bleeder plug.


      1. Front bleeder plug:

        Torque:
        10.8 N*m  { 110 kgf*cm, 8 ft.*lbf }

      2. Rear bleeder plug:

        Torque:
        11.0 N*m  { 112 kgf*cm, 8 ft.*lbf }

    6. Repeat the above procedure to bleed the air out of the brake line for each wheel.

  4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR


    1. Check the fluid level and add fluid if necessary.

      Fluid
      SAE J1703 or FMVSS No.116 DOT3 or equivalent

  5. CHECK BRAKE FLUID LEAKAGE

  6. INSTALL REAR WHEEL

    Torque:
    100 N*m  { 1,020 kgf*cm, 74 ft.*lbf }